Milling Machine Shield – Rockford
$ 92.07
Description These sturdy safety chip shields provide protection from flying chips, coolant, and rotating parts. They are usually applied to small drill presses, milling machines (mills), etc., and can be magnetically or permanently mounted. The shield can be attached to any ferrous surface on the machine by an 80-lb. pull, 3 1/4-inch diameter magnetic base. If a flat, smooth, ferrous surface is not available, a 3 1/4-inch x 5 1/4-inch mounting plate is also furnished with each shield. The impact-resistant, 3/16-inch-thick clear poly carbonate shield provides visibility to the point of operation. These chip shields adjust and lock in any vertical position.
Measure from the base of your palm to the tip of your middle finger. If your measurements fall between two sizes, choose the smaller one for a tighter fit or the larger one for a looser fit.
| Size | Length |
|---|---|
| XXS | 16cm |
| XS | 17cm |
| Small | 18cm |
| Medium | 19cm |
| Large | 20cm |
| X-Large | 21cm |
Based on Pilling gloves. Other brands may vary slightly.
